Technic Lego Fidget Spinners

To celebrate over 2000 views on my first Lego Fidet Spinner video, I have four more Lego Fidget Spinners to share with you.  If you are on an FLL team these fidget spinners are just for you!  All the parts to make them are included in your EV3 kits.  They are great to play with at FLL team meetings when your are thinking up the solution to one of the missions.

Flag Fidget Spinner

The picture above shows all the pieces you will need for the flag fidget spinner. 

Step One

Place orange flag on the end of each of the three axels.  Add the red bushing under the orange flag.  

Step Two

Add a white flag under the red bushing on each of the three axles.  Make sure it is facing the opposite direction of the orange flag.

Step Three

Step Four

Place each axle in one end of the tri-angle connector.   Make sure to place them so the orange flags all face the same way.

Place the axle with a stop on one end in the center of the tri-angle connector.  Place the half bushing on the end without the stop.  Enjoy spinning your new technic lego spinner!

Original (Tri) Fidget Spinner

The picture above shows all the pieces you will need for the orginal (tri) fidget spinner. 

Step One

Insert three of the axles in the tri-angle connector piece.

Step Two

Place a gear on the end of each of the three axles you attached to the tri-angle connector in step one.

Steps Three and Four

Place a bushing on the end of each of the three axles above the gear.  Then place a half bushing on the end of the remaining axle.

Step Five

Place the remaining axle through the center of the tri-angle connector piece.  Then finish off the fidget spinner by placing the last half bushing on the end of the axle.   Have fun spinning!

The Blender Fidget Spinner

This is a totaly orginal design that I created.  I call it The Blender.  All the pieces you need to make this fidget spinner are shown in the picture above.

Step One

Place the flag on the end of the axle.  Then place a bushing below the flag.

Step Two

Place the axle through the center of the beam.  Than add the other bushing on the end of the axle.  Next add the remaining flag to the end of the axle.  Make sure your flags point in the same direction. 

Step Three

Place studs on each side of each end of the beam.  Mixing and matching the stud colors will get you different looks when you spin it.

Step Four

Place the cones on the studs on the end of the beam.  Spin it and watch the different colors you get on each side.  Switch up the cone and stud colors to get even more looks!

The Bubblebee Fidget Spinner

The picture above shows the pieces  you will need to make the bubblebee fidget spinner.

Step One

Place a half bushing on one end of the each of the two smaller axles.

Step Two

Place a 2x2 round piece on each of the smaller axles below the half bushing.

Step Three

Insert each of the smaller axles into the angle connector.

Step Four

Place the remaining axle in the center of the angle connector.  Then place a bushing on the end.  Now you can spin and enjoy your fidget spinner!

Need Lego Technic Pieces?

You can get a 1 lb of random technic pieces on amazon.com.  Click on picture to get to product page.

This post contains affiliate links, which means that if you click on one of the product links and make a purchase, we'll receive a percentage of the sale.I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

How to Make Four Different Technic Lego Fidget Spinners
Tagged on:                                     

Leave a Reply